Standard Motor Connection Wiring Diagrams - InSinkErator SS-50 Installation, Care & Use Manual

DANGER
Electrical Shock
• Turn off all electrical supply to the disposer before attempt-
ing any work on it. Use a voltmeter or circuit tester to
ensure power is off.
• Installation must conform to all local electrical codes.
• All control centers and disposers must be carefully and
permanently grounded.
• A properly fused disconnect must be installed at the electri-
cal supply source for the control center.
Manual Three Phase Reversing Switch

STANDARD MOTOR CONNECTION WIRING DIAGRAMS

Wiring Diagrams
• Ensure that the control center voltage and phase match
the disposer motor and electrical supply. Check name-
plates on disposers and control centers for voltage and
phase specification.
• The disposer motor wiring connection is shown in the
disposer terminal box.
16
Property Damage
208/230 volts
Three Phase
12 Lead Motor
NOTE: Do not use this diagram to connect an
optional reversing control. Refer to the
diagram shipped with the disposer or
control.
Do not wire the solenoid valve in series
with the dispenser motor. Follow the
wiring diagram shipped with the
disposer.
When a grounded power input line is
used as one of the supply lines it must
be connected to the wire group
containing lead #1.