ekwb EK-Quantum Kinetic TBE DDC PWM Series Installation Manual page 11

EK recommends you use the EK-Quantum fittings with
EK-Quantum Kinetic TBE DDC series combo units. If you
use barbs, ensure that tubes are securely attached by
using the hose clamps or an appropriate substitute.
All unused ports should be blocked with the enclosed
G1/4 Plugs.
CAUTION
OUTLET port must always be placed on the marked spot.
Ports on the top of the reservoir should only be used as
Inlet ports with the enclosed Internal tube.
The INLET (suction) ports are those with the G1/4
threading plane.
Make sure not to use fittings or barbs with G1/4 thread
that is longer than 5mm!
- 11 -