Setting Strongness Of Drink; Brewer Stops; Setting The Brewer Stops; Fig. 12 Initial Situation Programming - BRAVILOR BONAMAT FRESHONE Operating Instructions Manual

6.2.3 Setting strongness of
drink
D Press the programming key (19.4) to start the
programming.
D Press one time the [Enter] key (5.7).

Fig. 12 Initial situation programming

D Select the drink involved
D Press four times the [Enter] key (5.7).
For 'mild coffee and strong coffee' press the
[Enter] key (5.7) only once!

Fig. 13 Strongness drink

D Set with the setting key (5.6 or 5.8) the
strongness.
TIP
– By pressing the setting key (5.6 or 5.8)
longer, you quickly to through the range.
– See table 2 for the factory settings.
– Write your own settings with a pencil in the
table.
Drink Factory setting %
'regular coffee' 50
'mild coffee' 40
'strong coffee' 60
'extra strong coffee' 66
'hot water' −
Table 2 Settings of the strongness of the drink
ECopyright Bravilor Bonamat B.V.
6.2.4
The FreshOne makes fresh coffee following the
vacuum principle. Measures of ground coffee and
hot water are added at the top of the brewer. The
piston of the brewer first presses air through the
filter paper to the coffee and the hot water and
after that stops for a few seconds to enhance the
extraction [S1] (adjustable between 0 and 10
sec.). Subsequently, the piston moves down
causing the coffee extract to be drawn through
the filter paper. Before the coffee extract leaves
the brewer, the piston stops again [S2] (also
adjustable between 0 and 10 sec.) to withdraw as
much liquid as possible from the coffee residue.
The filter paper with the coffee residue is
automatically transported to the litter bin, after
which the brewer is ready again for the next
cycle. The piston is then in the resting position
again, just above the outlet opening.
6.2.4.1
The brewer stops times have been set by the
manufacturer (table 3 ) and give a good result at
this setting. However, you as user can adjust the
values, as the circumstances are not necessarily
always the same.
D Press the programming key (19.4) to start the
programming.
D Press one time the [Enter] key (5.7).
D Select 'regular coffee' (5.1).
D Press five times the [Enter] key (5.7).

Fig. 14 Setting brewer stop 1

D Set with the setting key (5.6 or 5.8) the number
of seconds for [S1].
Set by you %
TIP
– Write your own settings with a pencil in the
table.
D Press again the [Enter] key (5.7).
−

Brewer stops

Setting the brewer stops

version
15
1.0