Cleaning The Exhaust Fan - BRAVILOR BONAMAT FRESHONE Operating Instructions Manual

TIP
– If the descaling has started in the meantime,
then push longer than 10 seconds on the
setting key (5.8) to stop the descaling
programme.
D Solve 100 gr. Renegite in
D Remove the plug from the pouring opening (29.).
D Pour the descaling solution in the opening with
the help of the delivered funnel.
WARNING
n Stop the descaling programme never when
you have already poured descaler into the
machine!
D Close the pouring opening again with the plug.
D Press the setting key (5.6) to start the
descaling.
The machine is now flushed with a mixture of
water and descaler. This takes about 15
minutes.
WARNING
n Heavy calcification will bring about a strong
reaction which will cause the descaling
solution to come into the litter bin through the
funnel–shaped feed–through.
At the end of the descaling programme the
hammer disappears from the display.
D Remove the plug from the drain hose (20.) and
let the water flow into the litter bin.
D Place the plug back on the drain hose.
D Push the drain hose back again.
D Pull the extension piece from the hot water
supply hose (25.) and place the end of the
hose into the locking spring (24.3) at the top of
the mixing basin (24.2).
D Close the cover (1.).
D Press the programming key (19.4).
D Close the door (3.).
D Put the drip–tray (9.) back.
Now the machine will be filled with water again
and the heating is started.
The descaling signal has been automatically
reset to zero.
ECopyright Bravilor Bonamat B.V.
7.2
The machine is provided with an exhaust fan to
exhaust the water vapour. This prevents the
1
/ liter of hot water.
2 inside of the machine and the coffee in the
ingredients container from becoming moist.
CAUTION
– The exhaust fan works continually when the
TIP
– Clean twice a year the blades of the exhaust
D Switch the machine off with the ON/OFF
TIP
– It is best to clean the fan after the Brewer has
D Use the delivered brush (18.) to clean the
Cleaning the exhaust
fan
machine has been switched on with the
ON/OFF switch (17.) and the door (3.) is
closed or the service key is in the opening
(22.).
fan to be sure of a good exhaustion.
switch (17.). The switch no longer shows a little
red square.
been taken out of the machine (§5.2.3.1).
blade wheel of the fan from the inside of the
machine.
19
version 1.0