Table of Contents
Advertisement
3.2.1
Boiling programme
WARNING
n During determining the boiling point hot water
Ó Ó Ó
can come out of the hot water outlet.
Only with putting for the first time into operation
of the FreshOne, the machine automatically
works through a boiling programme to
determine the boiling point of the water. This is
necessary because the boiling point depends on
the local atmospheric pressure. Thus, the boiling
point at sea level will be about 100_C, whereas at
2.000 m height it will be about 97_C.
After switching on the mains voltage, the water in
the boiler is first heated with full power until 80_C.
After that the water is heated with reduced power
until the boiling point is reached. The temperature
of the boiling point is now recorded in the
machine.
During the boiling programme the display shows
'100_C' with below that a flashing thermometer.
After 10 to 15 minutes the thermometer stops
flashing. The water in the boiler must first cool
down until the set operating temperature (§6.2.5).
To avoid waiting, you can press key (5.6) after
which the machine measures hot water and takes
in cold tap water. This speeds up the cooling
down of the water in the boiler and the machine is
ready for use.
D Switch the machine on by turning the ON/OFF
switch (17.) to ON. A little red square appears
on the switch. The machine starts filling up with
water. On the display all fields light up for a
moment.
D Close the door. All symbols on the display light
up for a moment.
4
version
1.0
3.2.2
Fill
D Open the door.
D Swing up the cover (1.) of the machine.
D Remove the cover (26.1) from the ingredient
container. Fill the ingredients container with a
Freshbrew grind to be used with this machine.
D Put back the cover on the ingredients
container.
D Place the filter paper (§5.1.4).
D Close the cover (1.) and close the door (3.)
with the key.
TIP
– It is possible to mount a discharge hose on
the drip–tray. At the back of the drip–tray
there is a spout. Bore a hole in this and slide
the hose on.
D Place the drip–tray (9.) in front of the machine.
TIP
– It is possible to place the machine in such a
way that the used coffee filter paper is not
collected in the machine, but below the
worktop. For this you can make an opening in
a part of the litter bin especially marked for
this (23.) and in the bottom of the machine
containing a part that can easily be removed.
You also should make an opening in the
worktop, right below the machine. In this way
the finished filter paper can be collected in a
litter bin with a larger capacity placed under
the worktop.
– Your specialist can supply a lead–through for
the worktop as accessory (§9.2.2).
ECopyright Bravilor Bonamat B.V.
Hide quick links:
Advertisement
Table of Contents
