3D Histech TMA Grand Master 2.0 User Manual page 35

TMA Grand Master 2.0 – User's Guide
2. The Layout Editor window is displayed.
3. When you create a new pattern, you define the block layout. Type the name of your new layout
into the Layout Name textbox (maximum length is 20 characters).
4. When working with special blocks that have different sizes than displayed by default, activate
the Custom Block Size function and set the correct measurements.
5. Select a value at the Tool Diameter section for the puncher and the drill bit sizes.
6. Select the size of the Gap between the holes.
7. Select the number of Columns and Rows.
8. Pattern alignment can be set at the Alignment pane of the window.
November 5, 2013 – Rev. 1 3DHISTECH Ltd.
5 Using TMA Grand Master
35(72)