Table of Contents
Advertisement
INDEX
WARNING
Escaping hydraulic fluid can cause serious
personnel injury. Relieve system pressure before
repairing, adjusting, or disconnecting. Wear
proper hand and eye protection when searching
for leaks. Use cardboard instead of hands
Figure
4-2) Keep all components (cylinders,
hoses, fittings, etc.) in good repair.
1. The hydraulic system will be filled with oil and fully
charged. Carefully hitch the 6510 to the tractor and
connect the hydraulic lift hoses. Check to make sure
the tractor hydraulic reservoir is full of the
manufacturer's recommended oil. Lower and raise
the unit to verify that the system is operating
correctly. Recheck tractor reservoir to make sure it is
within operating limits. With the lift cylinder fully
extended, install the 3 x 16-1/2 transport lockout
Figures
4-3. Storage location for lockout
Figures
4-4.
2. Always fully extend lift cylinder before removing
transport lockout. Unit can settle during
transportation causing the transport lockout to be
pinched.
3 X 16-1/2 TRANSPORT
LOCKOUT
Figure 4-3: Installed Transport Locks
TABLE OF CONTENTS
(See
See
See
General Operation
1. The horsepower requirements are typically 20-30
2. Operating speed is typically 4.5 - 6 mph. Excessive
3. Do not turn with the 6510 in the ground, this can put
Field Operation
1. Raise the unit to take the weight off of the transport
1/8" HAIR PIN
HOOKUP AND OPERATION
3 x 16-1/2 TRANSPORT
LOCKOUT
Figure 4-4: Stored Transport Locks
horsepower per foot of cut. This will vary widely due
to speed, depth, moisture, residue and types of soils.
Local dealers can help in making recommendations
for your areas.
speed can cause the unit to bounce, uneven depth,
and create a ridge on the outside edges. Too low of
speed may not allow the unit to properly fill in the
center furrow.
excessive side load on the gangs and hitch. Raise
the unit slightly when making turns to prevent
gouging and pushing a ridge.
locks. Remove the transport locks from the lift
cylinders Store the transport locks on the retainers
on the top of the frame.
See Figure
1/8" HAIR PIN
4-4.
4-3
Advertisement
Table of Contents
