Configuration; Configuration Checklist; Configuration Procedure - Siemens DMS8000 MP4 Series Installation And Configuration Manual

5 Configuration

5.1
5.2
Building Technologies
Fire Safety & Security Products

Configuration checklist

Verify that you have satisfied the items needed in the first checklist before proceeding
to the configuration checklist that follows.
Items Needed For Configuration
The MultiScope model and variant, i.e. the number of video inputs

The MultiScope parameter settings, including:

– Local address (0 to 99)
– IP address
The camera connections

Video application required for integrating Geutebrück MultiScope:

– Geutebrück Multiview
Plug-ins needed:

– #252101 (ST DV SIVMS/ST VD OPC)
– #353801 (OPCDVRST/OPC DVR ST)
Note: Plug-ins are installed during the software setup procedure. You can check that
the Plug-ins are actually available using the Composer Plug-in Installer in the
DMS8000 start menu.
Configuration overview
1. Add the Video Network Manager.
2. Add the folder for the MultiScope system.
3. Add the MultiScope node.
4. Configure the MultiScope variant and addresses.
5. Connect the cameras.

Configuration procedure

The following are the configuration procedures for a MultiScope unit:
Adding the Video Network Manager
1. Open the Composer project.
2. If not already done, add
- the Video Network Manager
- and the MultiScope driver.
Adding the folder for the MultiScope system
Optionally, create a folder for the MultiScope unit.

Configuration
Configuration checklist
A6V10067796_a_en
30.06.2013
5
11