Table of Contents
Advertisement
This menu is only displayed in case of METRIC operation.
SUBMENU
MESSAGE
ACC-01
ACC-02
ACCEss
ACC-03
ACC-04
ACC-05
ACCESS DISPLAY PROCEDURE
Press PRG to enter: the operator code used to access unit set-up and the progressive number of accesses
are displayed as described below:
1d. 0 000
The ID code used for access is shown on the display (password table). If access occurred via calibration
bridge, the identification code 0000 is displayed.
Press PRG to continue with the display of the progressive number of the access.
Pr. 0 000
The progressive number of the access is shown on the display (this value increases at each access and
is never zeroed). Press PRG to exit the access display procedure.
ACCESS DISPLAY
NAME
Procedure to display the last access of the
Access 01
Procedure to display the last access but one
Access 02
Procedure to display the last access but two
Access 03
Procedure to display the last access but three
Access 04
Procedure to display the last access but four
Access 05
DESCRIPTION
authorized staff.
of the authorized staff.
of the authorized staff.
of the authorized staff.
of the authorized staff.
TYPE
Spc
Spc
Spc
Spc
Spc
Page 41
Advertisement
Table of Contents
