Pavone Systems MC 315 Series Technical Manual page 40

TEST MENU
MENU MESSAGGE
S1GnAL
H1 rES.
PSuppL.
1nPut
tESt
oUtPut
CoN 1
CoN 2
FibEr
(*) Load cell tests refer to the channel enabled when accessing the set-up menu of the unit. Use the
relevant function key to switch the active cell.
INPUT TEST FUNCTIONS
After accessing the Input test function, the message
status of logical input, as per the following table:
VALUE MEANING
No input enabled
In 00
Input 1 enabled
In 01
Input 2 enabled
In 10
Inputs 1 & 2 enabled
In 11
OUTPUT TEST FUNCTIONS
After accessing the Output test function, the message
status of logical output, as per the following table. The output to be enabled is selected using the nu-
meric keys.
VALUE
out 0
0
out 1
1
out 2
2
out 3
3
out 4
4
out 5
5
out 6
6
Page 38
Displays the unit input signal in mV/V
Displays weight with a 10-fold resolution vs. the set one.
Displays the power supply measured by the unit.
Logical input testing procedure (see specific description).
Logical output testing procedure (see specific description).
RS485 COM1 serial port testing procedure (see specific description). Test.
RS485 COM2 serial port testing procedure (see specific description). Test.
COM3/COM4 optical fiber serial port testing procedure (see specific
description).
No logical output is enabled.
Logical output 1 is enabled, all the other outputs are disabled.
Logical output 2 is enabled, all the other outputs are disabled.
Logical output 3 is enabled, all the other outputs are disabled.
Logical output 4 is enabled, all the other outputs are disabled.
Logical output 5 is enabled, all the other outputs are disabled.
Logical output 6 is enabled, all the other outputs are disabled.
DESCRIPTION
in 00 is displayed, where 00 depends on the
out 0 is displayed, where 0 depends on the
MEANING
TYPE
Dis.
Dis.
Dis.
Test.
Test.
Test.