Removing The Wireless Lan Module - Clevo N150ZU Service Manual

Removing the Wireless LAN Module

1. Turn off the computer, turn it over to remove the keyboard
2. The Wireless LAN module will be visible at point
3. Carefully disconnect the cables
4. The Wireless LAN module
5
5. Reverse the process to install a new module (do not forget to replace all the screws and bottom cover).
a.
b.
2
3
(page 2 -
on the mainboard
1
& , and then remove the screw
2 3
(Figure 8c) will pop-up, and you can remove it from the computer.
c.
1
4
5) and battery (page 2 - 6).
(Figure 8a).
(Figure 8b)
4
5
5
Removing the Wireless LAN Module 2 - 13
Disassembly
Figure 8
Wireless LAN
Module Removal
a. Locate the WLAN.
b. Disconnect the cable
and remove the screw.
c. The WLAN module will
pop up and lift it out of
the computer.
Note: Make sure you
reconnect the antenna
cable to the "1 + 2"
socket (Figure 8b).

5.Wireless LAN Module
• 1 Screw