Removing The Keyboard - Clevo N150ZU Service Manual

Removing the Keyboard

1. Turn off the computer, turn it over.
2. Remove screws - from the bottom case
1 2
3. Open it up with the LCD on a flat surface before pressing at point
cific eject stick to do this) while releasing the keyboard in the direction of the arrow
4
4. Carefully lift the keyboard
6
board ribbon cable from the locking collar socket
5. Carefully lift up the keyboard
6. Reverse the process to install the keyboard (be careful not to bend the keyboard ribbon cable).
a.
2
b.
3
4
(Figure 1a).
up, being careful not to bend the keyboard ribbon cable
(Figure 1c).
8
off the computer (Figure 1d).
6
c.
1
c.
5
to release the keyboard module (use the spe-
3
as shown
5
. Disconnect the key-
7
8
6
6
Disassembly
Figure 1
Keyboard Removal
a.
(Figure 1b).
b. Release the keyboard by
pressing at point
c. Disconnect the keyboard
ribbon cable from the
locking collar socket.
d. Remove the keyboard.
7
8

4. Eject Stick
6. Keyboard
Removing the Keyboard 2 - 5
3 .