Graco Reactor 2 H-30 Repair Parts page 35

Hydraulic proportioning systems
Hide thumbs Also See for Reactor 2 H-30:
Table of Contents

Advertisement

Error
Location
Error
Error
Location
Location
V4MB
TCM
V4MH
TCM
WMC0
TCM
WMI0
TCM
WSUX
USB
WXUD
ADM
WXUU
ADM
Z1DH
Hose
Z4DH
Hose
Z6DH
Hose
334946H
Type
Description
Type
Type
Description
Description
High Voltage B
High Voltage Hose
Software Update
Required
TCM Fan Error
Configuration Error
USB
USB Download Error
USB Upload Error
Low Resistance
Hose Wire
High Resistance
Hose Wire
Sensor Error Hose
Wire
Cause
Solution
Cause
Cause
Solution
Solution
Incoming line
Ensure incoming system
voltage is too high
power is wired properly.
Verify voltage at each circuit
breaker is between 195 and
264 VAC.
Incoming line
Ensure incoming system
voltage is too high
power is wired properly.
Verify voltage at each circuit
breaker is between 195 and
264 VAC.
TCM software
Update the ADM with soft-
requires update
ware version 4.01.001 or
to use Hose
newer. See
Resistance Mode
Software, page
Fan inside TCM
Check for debris in the TCM
is not operating
fan and clear with forced air
properly
if necessary.
A valid
Inset a system token into
configuration file
the ADM and cycle power.
can't be found for
Wait until the lights on the
the USB
USB port stop flashing
before removing token.
Log download
Backup and reformat the
failed
USB drive. Retry download.
Custom language
Perform normal USB
file failed to upload
download and use the new
disptext.txt file to upload the
custom language.
Hose section
Re-calibrate the hose.
removed or
Follow the
replaced without
Procedure, page
re-calibration
Hose wire
Ensure hose wire
temperature is
temperature is above
too low
-4 °F (-20 °C).
Hose section
Re-calibrate the hose.
added or
Follow the
replaced without
Procedure, page
re-calibration
Hose wire
Ensure hose wire
temperature is
temperature is below
too high
221 °F (105 °C).
TCM is unable to
• Ensure at least 50 ft (15.2
sense hose wire
resistance
• If the error cannot be
Troubleshooting
Update ADM
71.
Calibration
65.
Calibration
65.
m) of heated hose is
connected to the system.
cleared or the error
regenerates consistently,
replace TCM.
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents