Installation - PROEL RMW10 User Manual

RMW10

5. Installation

Connect the RMW10 receiver to a mixer/amplifier, using the balanced or unbalanced output as follows:
Balanced connection:
Unbalanced connection:
Unbalanced connection with Mono jack
RCA connection
Connect the antenna, connect the power adaptor to the RMW10 and then to the mains power supply socket
Switch on the receiver.
Insert the batteries in the transmitter and switch on.
There are 2 modes for the operating frequency setting:
1) Manually select the frequency on the receiver and on the transmitter (see points 3 and 4)
2) Set manually the frequency on the transmitter (see paragraph 4) and proceed with automatic scan on the receiver ( see point 3)
Note: In the case that many wireless microphone systems operating at the same time, the automatic frequency receiver scan might lock
onto the operating frequency of another transmitter. The scan should be continued ensuring the correct combination is selected: receiver 1
coupled with transmitter 1 , receiver 2 coupled with transmitter 2 and so on.
22