Code Soft TP-290XIII Programmer's Manual page 10

[Notes]
§
§
§
§
14、ESC D n1...nk NUL
[Format] ASCII
Hex
Decimal
1 ≤ n ≤ 255
[Range]
0 ≤ k ≤ 32
[Description] Set horizontal tab positions
§
§
[Notes]
§
§
§
§
§
§
§
§
[Default] The default tab positions are at intervals of 8 characters (columns 9, 17, 25, ...)
for the font B (12 14).
[Reference] HT
15、ESC E n Turn emphasized mode on/off
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
[Description] Turn emphasized mode on/off
The DIP switch settings are not checked again.
The data in the receive buffer is not cleared.
Macro defined is reserved.
NV bitmap data is not cleared.
Set horizontal tab positions
ESC D
1B 44 n1...nk 00
27 68 n1...nk 0
n specifies the column number for setting a horizontal tab position from the
beginning of the line.
k indicates the total number of horizontal tab positions to be set.
The horizontal tab position is stored as a value of [character width x n]
measured from the beginning of the line. The character width includes the
right-side character spacing, and double-width characters are set with twice
the width of normal characters.
This command cancels the previous horizontal tab settings.
When setting n = 8, the print position is moved to column 9 by sending HT.
Up to 32 tab positions ( k = 32) can be set. Data exceeding 32 tab positions
is processed as normal data.
Transmit [n] k in ascending order and place a NUL code 0 at the end. When
[n] k is less than or equal to the preceding value [n] k-1, tab setting is finished
and the following data is processed as normal data.
ESC D NUL cancels all horizontal tab positions.
The previously specified horizontal tab positions do not change, even if the
character width changes.
Character width is absolute in standard mode and page mode.
ESC E
1B 45 n
27 69 n
THERMAL RECEIPT PRINTER
n1... nk NUL
n
9