Table of Contents
Advertisement
Operating with ACS-PAN-A Control Panel
The ACS 400V is delivered with an ACS-PAN-A control panel, which is an alphanumeric control panel
with LCD display and multiple languages. The control panel can be connected to and detached from
the converter at any time. If the control panel is detached when the panel is in local mode, then the ACS
400V will trip and stop. If the panel is detached in remote mode, then the ACS 400V will continue
operation as before. The panel can be used to copy parameters to other ACS 400V converters with the
same software revision can be viewed from (parameter 3301).
Control modes
Display modes
Green LED
Control Modes
The very first time the drive is powered up, it is controlled from the Control Terminal Block X1 (remote
control, REM). The ACS 400V is controlled from the control panel when the drive is in local control
(LOC).
Switch to local control (LOC) by pressing and holding the LOC/REM button until first LOCAL
CONTROL or later LOCAL, KEEP RUN is displayed:
•
If the button is released while LOCAL CONTROL is displayed, the panel frequency reference is set
to the current external reference and the drive is stopped.
•
When LOCAL, KEEP RUN is displayed, the current run/stop status and the frequency reference are
copied from the user I/O.
Start and stop the drive by pressing the START/STOP button.
Change the shaft direction by pressing the REVERSE button (parameter 1003 must be set to
).
REQUEST
Switch back to remote control (REM) by pressing and holding the LOC/REM button until REMOTE
CONTROL is displayed.
Shaft Direction
RUN >
< RUN
RUN > (or < RUN) Arrow head blinking rapidly
> (or <) Arrow head blinking slowly
OUTPUT MENU LOC REM RUN
MENU
MENU
Red LED
RESET
RESET
LOC/REM
ENTER
LOC
REM
REVERSE
• Drive is running and at setpoint
• Shaft direction is forward (>) or reverse (<)
Drive is running but not at setpoint.
Drive is stopped.
Run indicator
Shaft direction
UP/DOWN
ENTER
START/STOP
17
Advertisement
Table of Contents
