Table of Contents
Advertisement
Z I PP IE VOYAGE
T. MEDIAL SUPPORT PAD
Medial pad installation
a.
Raise the footrest up so that it is horizontal with the seat pan.
b.
Find the two holes (E) in the seat pan, located on both sides of the footrest tube
c.
Seat cushion must be attached.
d.
Slide the metal bracket through the slot in the cushion and align holes in the bracket
with the holes in the seat pan.
e.
Attach the Medial pad (F) to the seat pan with hardware (G).
U. ANTERIOR SUPPORTS
When deciding if you should use Anterior supports, always consult your healthcare advisor.
Some children, due to their disability level or physical condition, may need anterior supports to help
maintain proper posture or body position. Such devices include head straps, shoul-der straps, thoracic
strap systems, pelvic supports, and belts.
Risks of injury with head supports and how to avoid them.
Excess movement or migration of the pelvis- This may cause the supports to displace. If this
occurs, severe injury to the child could result.
To avoid risks:
1.
It is VITAL to keep the child in a stable pelvic position.
2.
Anterior supports should ONLY be used with seat, back, and pelvic supports or belts that keep
the child from sliding down in the seat.
3.
Anterior supports must be fitted by your authorized dealer and your healthcare pro-fessional.
4.
After fitting, anterior supports, they should ONLY be placed and adjusted by trained
professionals.
5.
DO NOT leave the child unattended when using anterior supports.
V. HEAD SUPPORTS
(Optional) (ADVANCED SEATING)
Attaching Head Support in Lower Positions
a.
Remove back cushion and unsnap rear shell upholstery exposing two head support mounting
holes at center back of inner seating shell.
b.
Insert t-nut (C) from inside of shell attaching headrest mount with supplied screws.
c.
Tighten the hardware securely.
Head Support Adjustment & Higher Position Mounting
a. You can adjust height of the headrest with the height adjustment screws (A).
b. You can adjust anterior/posterior depth, by loosening the adjustment screws (B).
c.
You can adjust the pad tilt and angle by adjusting the collar, and collar bolts.
d.
To raise the headrest to a higher position you can invert the bracket
(Figure 61).
Attaching Headrest Pad
a.
Remove vinyl collar cover and insert over the knurled headrest ball.
b.
Loosen collar screws (E) enough to slip collar onto knurled ball.
c.
Be sure to evenly tighten the collar by first loosely starting the screws.
d.
Using the 5/32" hex key, tighten the screws 1/2 turn alternating between the two sides until
there is an even gap as shown (F). Make sure collar alignment is even and secure. if collar is
unevenly tightened as shown (G), injury to the child could result.
245797 Rev. A
(MODERATE SEATING)
WARNING
IX. DEALER SERVICE & ADJUSTMENT
60 61
.
62
63
64
(D) as shown in
26
F
G
60
61
62
63
Advertisement
Table of Contents
