Table of Contents
Advertisement
Z I PP IE VOYAGE
E. ADJUSTABLE CONTOUR CUSHION ADJUSTMENT
(ADVANCED SEATING)
The contoured seat cushion comes in three seat lengths, short, medium, and long. The short seat is
5" (127mm) long, the medium seat is 7" (178mm), and the long is 9" (229mm). These cushions can be
grown by an additional 3" (76mm) by adding a 3" (76mm) growth strip at the back of the cushion. The
front and rear section of the cushion (D) has Velcro ® attachment points for positioning the adductor
wedges provided. They attach to the front and rear section of the cushion under the foam overlay.
The foam overlay attaches to Velcro ® at the back of the seat.
Adding growth strips
a.
Unzip seat cover and fold the top over the front edge to expose the cushion.
b.
Lift the foam overlay piece away from the Velcro® attachment, using care not to tear the foam.
c.
Grasp the rear foam section at the middle and lift it from the Velcro
d.
Add either the 2" (51mm) or the 3" (76mm) growth strip at the back of the front foam section
assuring that the angled edges and sides align, and black foam is facing down.
e.
Re-attach the rear section assuring the angled edges and sides align.
f.
Adjust the adductor wedges as needed and position the foam overlay over the cush-ion and
attach to the Velcro
®
at the rear of the seat.
g.
Close the zipper around the cushion and install into the unit.
36
Cleaning the seat cover
a.
Unzip the cover (E) along the edge.
b.
Remove the cushion assembly from the Velcro® attachment inside the cover.
c.
The fabric seat cover should be hand washed with laundry soap, thoroughly rinsed with clean
water, and air dried.
d.
The foam cushion pieces may be wiped down with soap and water. Always be sure they are
completely dry before replacing the fabric cover.
e.
Place the cushion into the fabric cover and onto the Velcro
cushion aligned with the front edge of the cover.
f.
Pull the cover over the cushion and close the zipper around the cover.
F. PLANAR CUSHION WITHOUT LATERAL SUPPORTS
(ADVANCED SEATING)
Adding growth strips
The standard cushion without lateral hip supports comes in three seat lengths, short,
medium, and long. The short seat is 8" (203mm) in length, the medium seat is
10" (254mm), and the Long is 13" (330mm).
G. SHOULDER STRAP HEIGHT ADJUSTMENT
(ADVANCED SEATING)
a.
Open the exterior back panel cover from the rear of the device to expose the back growth
slots, and adjustment screws.
b.
Loosen, do not remove (4), screws (A) through the access holes behind the back plate on
each side. Adjust shoulder strap bar to proper height. Tighten all of the adjustment screws to
45 in-lbs (5Nm) (do not over-tighten) and then readjust the shoulder straps for a comfortable
fit.
H. BACK CUSHION HEIGHT ADJUSTMENT
a.
Fit the back cushion to the positioning plate at proper height.
b.
Exchange appropriate back cushion inserts if a gap is present at the bottom of the back cushion.
I. SEAT TO BACK ANGLE ADJUSTMENT
(ADVANCED WITHOUT RECLINE OPTION)
For ease of adjustment, and safety of the dependent, remove the occupant before any adjustment
is made. Always stabilize the mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
245797 Rev. A
®
attachment.
®
with the front edge of the
37
(ADVANCED SEATING)
38
WARNING
20
IX. DEALER SERVICE & ADJUSTMENT
35
E
35
36
37
38
Advertisement
Table of Contents
