Table of Contents
Advertisement
Z I PP IE VOYAGE
I. SEATING INSTALLATION
BEFORE installing the seating shell, always check that the mobility device is completely
unfolded and in the locked position, and that all four wheels are locked in place. The seating
shell should never be installed with a seated occupant. Always remember to stabilize the
mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
The seating shell has a latch mounted underneath the seat plate. The interface on the base
is the counterpart to the latch and mates with the latch. The seating shell may be installed
so that the child can face either frontwards or rearwards. Installation is the same in either
direction.
Using the latch lock
NOTE – The latch under the seat plate has a lock that can be used to provide additional
securement after the seat is installed.
a. BEFORE attaching or removing the seat to or from the base, the latch lock (K) MUST
be slid to the right (unlocked position) as shown in Fig 14.
b. To prevent inadvertent activation of the seat latch, slide the latch lock to the left as
shown in Fig 15 AFTER the seat is fully secured to the base (you cannot attach seat to
base while lock is engaged).
Rotating the seat shell direction
a. Lock the wheels, remove the seat.
b. Be sure the Tilt setting is at the "home" or 0° position. Do this by squeezing the
Tilt Release lever and letting the "Slide-n-Lock" (Receiver) Plate spring flat.
c. STEP 1: Press the Gold Button, Nmbered 1 (A) on the Slide-n-Lock plate and
rotate the plate until it stops (Fig 16).
d. STEP 2: Pull the Pin (B) with one hand and rotate the Tilt Limiter Sleeve (C) with
your other hand* (Fig 17 and 18).
-NOTE: Only rotate the Tilt Limiter Sleeve in the process of Rotating the Plate.
*When the seat is forward facing the Tilt Limiter Sleeve should be rotated
Rearward, when the seat is rearward facing the Sleeve should be rotated Forward.
e. STEP 3: Finish rotating the Plate 180° until it locks into place (Fig 19).
Install the seating shell
NOTE - When installing the Moderate Seating System in the rearward facing direction, raise
the footrest to about a 5 degree angle, to clear the stroller base crossbar and allow seat to
lock into the receiver.
a. Make sure the seat is in the fully upright position (no recline or tilt).
b. Ensure all positioning straps and accessories are out of the way and will not interfere
with the seat from fully engaging the receiver.
c.
For moderate seating system only: Line up the alignment tag (D) with the
support cross bar (E) on the base (Fig 20).
d.
Lower the seating shell so that the seating shell and mounting plate are in contact.
e.
Slide the seat backwards evenly. You should hear an audible click. Check the
secure engagement to the base by pulling up on both sides. If it does not move
or tilt, the seating shell is now locked and has been installed properly.
f. Once locked into place, add the occupant for transportation and/or adjustment.
16 17
18 19
14 15
WARNING
20
20
E
15
VIII. USE AND MAINTENANCE
245797 Rev. A
14
15
16
17
18
19
Advertisement
Table of Contents
