Table of Contents
Advertisement
Z I PP IE VOYAGE
J. REMOVING THE SEATING SHELL
BEFORE removing the seating shell, always remove the occupant to a safe location. Failure to do so
may result in injury to the dependent, and/or caregiver. Always remember to stabi-lize the mobility
device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
After removing the occupant:
a.
Make sure the seat is in the fully upright position (no recline or tilt)
b.
Pull and hold release lever (F) so that it disengages from the receiver, slide the seating shell
forwards and lift the seating shell from the base.
c. The seating shell is now ready to be inspected and/or stored
22
K. GRAB
BAR
Always stabilize the mobility device before performing the action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
Insert or remove the Grab Handle
a.
Be careful to avoid pulling or crimping any life support tubing that may be attached to the child.
This adjustment can create a pinch point, so be careful to remove any obstruction, and/or
clothing that could get stuck in this area.
b.
The adjustment is made from the front of the device. Depress both upper detent pins
(H)
simultaneously, and either insert or remove the Grab
c.
If you are inserting the Grab
of the locking hole (J).
d.
Pull up on the
bar
to make sure that it is locked into place.
e.
Depending on preference, grab bar is reversible.
L. TILT IN SPACE ANGLE ADJUSTMENT
BEFORE using the tilt adjustment, always check that the mobility device is completely unfolded and in
the locked position, and that all four wheels are locked in place. Be careful to avoid pulling or
crimping any life support tubing that may be attached to the child. Always remember to stabilize the
mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
Tilt adjustment
a.
Remove the safety pin (A) to allow tilt.
Support the seating shell with one hand and release the tilt lever(B) on the
b.
frame. Position shell to the desired angle adjustment. The back support, and seating support
components, including the footrest
Release the handle and gently pull on the seating shell to make sure it is locked in the new
c.
position. Replace the safety pin to lock out the adjustment.
d. This adjustment can change the balance of the device slightly so it is good to check
that there is no danger of tipping with the new setting.
M. RECLINE ADJUSTMENT
BEFORE using the recline adjustment, always check that the mobility device is completely unfolded and in
the locked position, and that all four wheels are locked in place. Be careful to avoid pulling or crimping any
life support tubing that may be attached to the child. Always remember to stabilize the mobility device
before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
•
If equipped with shoulder harness, loosen the shoulder straps to allow room for the recline.
245797 Rev. A
21
WARNING
.
bar
Bar
(G), push the
bar
in far enough so that the detent pins pop out
23
WARNING
will
move together.
24
WARNING
(G)
back
side of the
16
VIII. USE AND MAINTENANCE
21
22
23
24
Advertisement
Table of Contents
