Software Update; Updating Groundcontrol Software - PRG GroundControl Remote Followspot System User Manual

Table of Contents

Advertisement

SOFTWARE UPDATE

Updating GroundControl Software

GroundControl software is updated using the two access ports (Figure 27) available on the underside of the Control
Arm:
+
Port 1 (DMX) - used to load firmware into the Control Arm's Switch Board.
+
Port 2 (Ethernet) - used to load firmware into the Control Arm's main board, the GC Truss Box, and the GC
luminaire (connected to the arm).
To update main board, truss box, or luminaire:
Step 1. Connect Truss Box and Luminaire to GC Controller as normal.
Step 2. Connect Ethernet cable between computer and Control Arm Access Port 2 (Figure 27).
Step 3. Open required .jar file.
Step 4. If computer has more than one Ethernet interface available, select appropriate network interface from drop-
down menu.
Step 5. Click Start Download button. Touchscreen display will change to bootloader screen and show load
progress.
Step 6. Wait for download to complete.
Step 7. After download, the updated version can be verified in the Information menu:
GROUNDCONTROL™ REMOTE FOLLOWSPOT SYSTEM™ USER MANUAL
54
Figure 27: Access Ports
DMX512
Ethernet
1
2
ACCESS PORT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gc rfs

Table of Contents