Edge/Frost
Edge and Frost can be adjusted using the EDGE and FROST knobs on the Control Arm (Figure 23). The knobs will
control Edge and Frost respectively, unless the Manual Control software menu is selected, in which case the three
knobs will control parameters of the selected mechanism. (Refer to
information.)
Beam Iris
The Beam Iris can be adjusted using the IRIS knob on the Control Arm (Figure 23).
The knob's Iris function can also be swapped with the currently assigned Zoom fader (see below) using the "Swap Iris
& Zoom" option available in the Options software menu. (Refer to
Zoom/Intensity
Zoom and Intensity can be scaled using their respective faders on the Control Arm. In default mode, Zoom is
controlled by the front fader (Figure 23), and Intensity by the rear fader (Figure 24). To swap the fader functions,
change the "Fader Mech Assignment" in the Options software menu. (Refer to
Zoom In/Out
The camera view can be zoomed in and out by pressing the ZOOM buttons on the Control Arm (Figure 24).
The [+] knob zooms in, while the [-] knob zooms out.
GROUNDCONTROL™ REMOTE FOLLOWSPOT SYSTEM™ USER MANUAL
30
EDGE
FROST
Figure 23: Front Controls
CAMERA
ZOOM
-
DAY/NIGHT
+
CAMERA
IRIS
Figure 24: Rear Controls
"Manual Control Menu"
"Options Menu"
on page 23.)
IRIS / ZOOM KNOB (configurable)
ZOOM / INTENSITY
FADER (configurable)
"Options Menu"
RETICLE
BLACKOUT
INTENSITY / ZOOM
FADER (configurable)
on page 25 for more
on page 23.)