Controller - PRG GroundControl Remote Followspot System User Manual

Controller

The GC Followspot Controller should be placed on a sturdy, flat surface large enough to accommodate the stand.
Note: The cables should be positioned on the opposite side of the operator.
To install GC Followspot Controller:
Step 1. Extend legs of slider stand and place on floor (Figure 13). Lock in place by tightening two bottom locking
knobs. To ensure stability do not allow the center post to come in contact with the floor / ground.
Step 2. Adjust stand to desired height and tighten locking knob.
Step 3. Insert pin of RFS Control Arm Interface Box into the receiver socket of the stand. Tighten top locking knob
to prevent rotation of Interface Box.
Step 4. Attach Monitor to monitor mount.
Step 5. Connect HDMI Cable from Monitor to Control Arm. (Monitor HDMI Cable is bundled with its Power Cord.)
Step 6. Connect Monitor Power Cord from Monitor to Control Arm. (Monitor Power Cord is bundled with its HDMI
Cable.)
Monitor
Monitor Mount
Slider Stand
Locking Knob (4)
Figure 13: Assembling GC Followspot Controller
Power
HDMI
NOTE: To ensure stability, do not allow the center
post to come in contact with the floor / ground.
GROUNDCONTROL™ REMOTE FOLLOWSPOT SYSTEM™ USER MANUAL
13