Connecting Power And Data - PRG GroundControl Remote Followspot System User Manual

Connecting Power and Data

Refer to Figure 14 on the following page.
To connect power and data:
Step 1. Connect opticalCON Armored Quad Fiber cable (up to 2000 feet) from GC Followspot Controller to Truss
Box.
Step 2. Connect 5-pin XLR cable from Truss Box to fixture's DMX Input connector. (Part of Truss Box Cable
Bundle.)
Step 3. Connect 4-pin XLR cable from Truss Box to fixture's Camera Control connector. (Part of Truss Box Cable
Bundle.)
Step 4. Connect BNC cable from Truss Box to fixture's Video connector. (Part of Truss Box Cable Bundle.)
Step 5. If required, connect DMX Console to GC Followspot Controller.
Step 6. If required, connect HD-SDI LD Preview Monitor to GC Followspot Controller.
WARNING: Turn off the mains circuit breaker
Power Cables to the devices.
WARNING: Éteignez le disjoncteur du réseau avant de brancher ou de débrancher les câbles Neutrik
powerCON AC alimentation aux périphériques.
Step 7. Connect fixture's AC Line Cord from power source to fixture. (Dress and secure all cables so that they will
not interfere with fixture head or yoke movement.)
CAUTION: The Truss Box should be powered from an independent circuit separate from the fixture.
CAUTION: La Truss Box devrait être alimenté par un circuit indépendant séparé de l'appareil .
Step 8. Connect Truss Box AC Line Power Cord from power source to Truss Box.
Step 9. Connect Controller AC Line Power Cord from power source to GC Followspot Controller .
GROUNDCONTROL™ REMOTE FOLLOWSPOT SYSTEM™ USER MANUAL
14
before
connecting or disconnecting the Neutrik powerCON AC