Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean Lt - Whirlpool EDl9VK Use And Care Manual

Install properly. ,.
'1. Allow 1/2 inch (1.25 cm) space on each side and at
the top of the refrigerator for ease of installation.
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wider
3. The refrigerator back can be flush against the wall.
Level refrigerator-freezer.. .
Levelling SK4
1
Front Roller
Right to Raise;
Lett to Lower
1, Remove base grille [see page 7 1,
2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.
4. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
lnslde
labels before using the refrigerator
To remove any remalnlng glue:
I. Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (I
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasollne, car-
bon tetrachlorlde, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 9.
Plug it in...
j-prong grounding
type wall receptacle,
'I
&prong
I
grounding plug
t
Retrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extenslon cord. Use a recep-
tacle which cannot be turned off wlth a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.