Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET20MK Use & Care Manual

Install properly.. .
1. Allow '/2 inch (1.25 cm) space on each side and at
the top of the refrigerator for ease of installation.
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wider
3. The refrigerator back can be flush against the wall.
Level refrigerator-freezer.. .
Use Screwdrlver
Right to Raise;
Left to lower
I, Remove base grille [see page 7 ).
2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.
4.
Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachioride, etc. These can damage the
materlai.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 9.
Plug it in...
J-prong grounding
type wall receptacle
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.