Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET12DC Use And Care Manual

Cycle defrost refrigerator-freezers
Hide thumbs Also See for ET12DC:
Table of Contents

Advertisement

Install
properly..
.
1. Allow 3 inches (75 cm] between
overhead
cabi-
nets and refrigerator
top.
2. Allow
at least an inch (2.5 cm) between
the
refrigerator
condenser
on the back and the wall.
3. Allow
% inch (1.25 cm]
on each
side of the
refrigerator
for ease of installation.
4. If the refrigerator
is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened
wider
Level refrigerator-freezer..
.
1. Keep the 4 bolts that hold refrigerator
in shipping
crate. They are the levelling
legs.
2. Screw these bolts all the way into bolt holes at the
bottom
corners of refrigerator.
Move refrigerator
into place.
3. Adjust each leg until the refrigerator
won't rock.
4. Adjust front legs to level the refrigerator
- To raise corners, turn legs in direction
shown.
- To lower corners, turn legs in direction
shown.
5. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining
glue:
I. Rub'briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing
detergent
solution (1
teaspoon
detergent
in 1 quart warm water] before
removing
glue as described
in step 1.
DO NOT USE rubbing alcohol
or flammable
or
toxic solvents, such as acetone,
gasoline,
car-
bon tetrachlorlde,
etc. These can damage
the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the retrlgerator
at the front.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning
instructio
on page
7,
Plug it in...
3-prong grounding
type wall receptacle
Retrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused
and
properly
grounded
electrical
supply
is re-
quired.
It is recommended
that a separate
circuit
serving only this appliance
be provided.
Do not use an extension
cord. Use a recep-
tacle which cannot be turned otf with a switch
or pull chain.
See individual
electrical
require-
ments and grounding
instruction
sheet in your liter-
ature package.
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Et14dc

Table of Contents