Dhw Configuration - Keston HEAT 2 45 Installation & Servicing

Pump protection. To enable seizure
protection on pumps/valves connected to
the HC, select 'Yes'.
Configure pump protection?
No
Yes
Configure pump protection?
No
Yes
DHW priority. If the HC is requried to
give priority to any DHW demands in the
system then select 'Yes'.
DHW priority?
No
Yes
DHW priority?
No
Yes
Operating mode. The operating mode of
the HC can be set from a scrolling field,
once this is set then the HC configuration
is completed by selecting 'Done'.
Operating mode
Standby
Done
Operating mode
Time clock single day
Done
Operating mode
Time clock multiple day
Done
Operating mode
Day
Done
Operating mode
Night
Done
Installation & Servicing
SECTION 2 - INSTALLATION
The HC has now been configured and the
display will return to:
Select HC to configure
HC1 Boiler1.1 ü
Done
Note, that the HC number now has a
tick next to it showing that it has been
configured. If you have completed the
HC configuration, select 'Done'.
Select HC to configure
HC1 Boiler1.1 ü
Done

2.29.7 DHW Configuration

DHW circuit selection for configuration.
Select the DHW circuit from the available
DHW circuits in the list:
Select DHW to configure
DHW1 Boiler 1
Done
Local DHW Circuit
If the Master boiler has its own independent
DHW circuit then select 'Yes', if not select
'No'.
Local DHW circuit
No
Yes
Local DHW circuit
No
Yes
DHW pump location. If the DHW circuit has
an individual DHW Pump connected then
select the output that is used to control it
from the list. Otherwise select 'None'.
Select loc'n of DHW pump
None
PWM/0-10V ()
MFR1 ()
Select loc'n of DHW pump
None
PWM/0-10V ()
MFR1 ()
MFR2 ()
Select loc'n of DHW pump
PWM/0-10V ()
MFR1 ()
MFR2 ()
MFR3 ()
Select loc'n of DHW pump
MFR1 ()
MFR2 ()
MFR3 ()
MFR4 ()
Select loc'n of DHW pump
MFR2 ()
MFR3 ()
MFR4 ()
Select loc'n of DHW pump
MFR3 ()
MFR4 ()
47