Plant Settings - Keston HEAT 2 45 Installation & Servicing

Two Heating Circuits:
Set HC number
HC 01 Boiler 1.1
HC ## Boiler 1.2
Done
Set HC number
HC 01 Boiler 1.1
HC 02 Boiler 1.2
Done
Set HC number
HC 02 Boiler 1.2
Done
The system will now scan the known
devices on the bus to determine what
DHW circuits are available in the boiler
for configuration:
Once this is completed, the display will
prompt with the available DHW circuits so
that they may have DHW circuit numbers
allocated, and then later configured.
Set DHW number
DHW ## Boiler 1
Done
If any DHW circuits are required for the
boiler then number them sequentially
from 1. If there are no DHW circuits to be
configured to this boiler just move on past
by selecting 'Done'. Example:
Set DHW number
DHW 01 Boiler 1
Done
Set DHW number
DHW 01 Boiler 1
Done
The system will now configure the System
Manager for these circuits.
40
SECTION 2 - INSTALLATION
The system will now scan the known
devices on the bus to determine what
Plant functions are available in the boiler
for configuration:

2.29.4 Plant Settings

If you wish to configure any of the
following plant functions, then select 'Yes',
if not continue by selecting 'No' and move
to Section 2.28.3. ONLY configure these
functions here if you are not going to use
Configure plant?
No
Yes
Configure plant?
No
Yes
them in any HC's or DHW circuits.
Hydraulic Separation:
If the boiler has Hydraulic Separation
from the intermediate or final circuits in
the heating system then set this Option
to 'Yes':
Hydraulic separation?
No
Yes
Hydraulic separation?
No
Yes
Shared Boiler Pump:
If the Master boiler has a pump that is
shared across the plant then select the
output that is used to control it from the
list. Otherwise select 'None'.
Loc'n of shared boiler pump?
None
PWM/0-10V ()
MFR1 ()
Loc'n of shared boiler pump?
None
PWM/0-10V ()
MFR1 ()
MFR2 ()
Loc'n of shared boiler pump?
PWM/0-10V ()
MFR1 ()
MFR2 ()
MFR3 ()
Loc'n of shared boiler pump?
MFR1 ()
MFR2 ()
MFR3 ()
MFR4 ()
Loc'n of shared boiler pump?
MFR2 ()
MFR3 ()
MFR4 ()
Loc'n of shared boiler pump?
MFR3 ()
MFR4 ()
System Pump:
If the boiler has a Plant System Pump
connected then select the output that is
used to control it from the list. Otherwise
select 'None'.
Once an output has been configured the
selected function is shown in brackets
behind the output name.
Select loc'n of system pump?
None
PWM/0-10V ()
MFR1
Select loc'n of system pump?
None
PWM/0-10V ()
MFR1 ()
MFR2 ()
Select loc'n of system pump?
PWM/0-10V ()
MFR1 ()
MFR2 ()
MFR3 ()
Select loc'n of system pump?
MFR1
MFR2 ()
MFR3 ()
MFR4 ()
Select loc'n of system pump?
MFR2 ()
MFR3 ()
MFR4 ()
Select loc'n of system pump?
MFR3 ()
MFR4 ()
Installation & Servicing