Table of Contents
Advertisement
Quick Links
4201 LIEN RD. • MADISON, WI 53704
Phoenix DryMAX 50Hz - LGR Dehumidifier
The Phoenix DryMAX LGR Dehumidifier
•
LGR Capacity - Removes moisture even in dry
conditions for deep drying.
•
Energy Efficiency - Removes 36 Liters per day (76
pints) at AHAM while drawing only 3.2 amps.
•
Smallest Footprint Large Category Dehumidifier.
•
Slide Out Handle with Recessed Wheels for Easy
Maneuverability and Compact Storage.
•
Integrated Cord and Hose Management for
Transportation and Storage.
•
Bright, 4 Line Control Panel – Displays the Most
Common Readings without the Need for Scrolling.
•
Status Light Indicator – Tell at a Glance What
Operating Mode the Unit is in.
•
Integrated, Superior Stacking for Transportation and
Storage.
•
263 M
/hr (155 CFM) - Optimized process air speeds
3
drying and provides static pressures for ducting.
•
Plastic Housing - Rugged roto-molded housing resists
dents and scratches
•
Outlet Ducting - 10" lay flat exhaust.
•
Pleated Media Air Filter – MERV 8
•
Lighted cord - Easy to determine power to the unit.
Toll-Free in USA 1-800-533-7533 or
1-608-237-8400
OWNER'S MANUAL
Installation, Operation & Service Instructions
– READ AND SAVE THESE INSTRUCTIONS –
USEPHOENIX.COM
The Phoenix DryMAX is 6% smaller than the closest
dehumidifier and yet it still has an integrated handle and
wheels as well as onboard storage for the power cord and
condensate hose! The all-new Phoenix Micro-Channel
condenser allows us to pack so much performance into such
a small dehumidifier.
The feedback on the stacking of the AirMax was so positive
we made sure to build it into the Phoenix DryMAX.
We've also added a new four line display which provides you
with all the information you need to take readings directly
from the home screen.
A new Status Bar is located at the top of the new control
panel to give you instant feedback about the dehumidifier
from across the room.
Remove only four fasteners and you have easy access to
service the unit.
Phoenix DryMAX
Part No. 4036150 (RED)
Patent Pending
Specifications subject to change without notice.
WISCONSIN
1
Phoenix now offers
this unit in both
Red and Blue
4036290 (BLUE)
TS-1017
11/18 Rev. A
Advertisement
Table of Contents
Related Manuals for Phoenix Therma-Stor DryMAX 4036150
Summary of Contents for Phoenix Therma-Stor DryMAX 4036150
-
Page 1: Introduction
Energy Efficiency - Removes 36 Liters per day (76 pints) at AHAM while drawing only 3.2 amps. The feedback on the stacking of the AirMax was so positive we made sure to build it into the Phoenix DryMAX. • Smallest Footprint Large Category Dehumidifier. -
Page 2: Table Of Contents
3.2 Electrical Requirements ..........3 3.3 Control Panel ..............3 The Phoenix DryMAX conforms to unified standard IEC 3.3.1-3.3.23 How to use ......... 3-6 60335-2-40 and meets CE requirements. 3.4 Condensate Removal ..........6 3.5 Ducting .................7... -
Page 3: Electrical Requirements
3.2 Electrical Requirements 3.3.3 Navigation The Phoenix DryMAX plugs into a common grounded outlet on a 15 amp circuit. It draws 3.2 amps at 27°C (80°F), 60% RH. If used in a wet area, a ground fault interrupter (GFI) is... - Page 4 3.3.7 Humidistat Mode 3.3.9 Humidistat Fan Mode Press the Set button to toggle the Humidistat Fan mode from Always On to Auto. Press the Next button to confirm selection and advance to the next screen. Light Bar = On The light bar colors and animations will persist while in Settings.
- Page 5 Light Bar = On Light Bar = On The light bar colors and animations will persist while in The light bar colors and animations will persist while in Settings. Settings. 3.3.15 About This Device 3.3.12 Dew Point The following information is displayed on the About this The screen displays the ambient dew point.
-
Page 6: Condensate Removal
Press the Set button to toggle the Fan On/Off. 3.4 Condensate Removal Press the Next button to advance to the next screen. The Phoenix DryMAX is equipped with an internal condensate pump to remove the water that is condensed during dehumidification. This allows the condensate to be pumped up to 6m with the attached hose. -
Page 7: Ducting
The duct and collar may then be quickly attached to the Phoenix DryMAX by snapping the collar over the four exhaust tabs. -
Page 8: Storage And Freeze Protection
The refrigerant is cooled and There are two issues to consider when the Phoenix DryMAX condensed by giving up its heat to the air that is about to is stored between uses and both pertain to water trapped be discharged from the unit. -
Page 9: Air Mover
Unit removes some water but not as much as expected. 4. Remove control board cover 1. Air temperature and/or humidity have dropped 5. Unthread thermistor probe wire from harness 2. Humidity and/or temperature measurement is out of 6. Unplug thermistor probe connector on control board calibration Reassemble thermistor probe and dehumidifier using 3. -
Page 10: Wiring Diagram
7 Wiring Diagram BLK (CORD) WHT (CORD) WHT-12 WHT-6 RED-3 LINE BLK-4 COMPRESSOR CAPACITOR BLK-5 BLK-13 YEL-2 POWER BOARD WHT-10 CONTROL BOARD RH-OUT RH-IN AUX EVAP FLOAT FLOAT SWITCH TEMP/RH TEMP/RH SENSOR SENSOR THERMISTOR PROBE PRESS PUMP SWITCH BLK-5 BLOWER BLK-11 WHT-10 BLK-13... -
Page 11: Service Parts
4036959-02 4036934-01 Condensate Pump Micro Channel Condenser 4036957 4038479 Float Switch Compressor 4034716-03 Evap Thermistor 4036848 Humidity/Temp Sensor 4036943 4024916 Handle Bushing RH Condensate Hose 4036942 4037847 Handle Weldment Handle Bracket RH 4036944 Handle Bushing LH 4037848 Handle Bracket LH 4037429 4036927 Control Board... -
Page 12: Warranty
(but all warranty periods will be extended by the period of time, if any, that the Phoenix DryMAX Dehumidifier is out of service while awaiting covered warranty service).
Need help?
Do you have a question about the Therma-Stor DryMAX 4036150 and is the answer not in the manual?
Questions and answers