Lilin D/N HD AF IR IP CAMERA Installation Manual

D/N HD AF IR IP CAMERA
Part Description & Dimensions
116
4
112
3
ø95
84
8
84
9
Factory default button
Top Case
1 13
Restores the server back to factory default settings.
Bottom Case
2
Micro SD card slot
Lens
3 14
Auto Focus button
Sun Shield
4 15
Live Video Output Connector
Bottom Box
5 16
LED Indicators
Top Box
6 17
Green (Power): Indicates system status.
Side Hole
7
Green (Link): Illuminates when the camera is
Bottom Hole
8
Hole Plug
9
Orange (ACT): Flashes when data communication
10 Adjustment Screw A
Adjustment Screw B
11
Adjustment Screw C
12
The IP camera will automatically adjusts the camera lens to obtain focus after press
the AF (Auto Focus) button continuously for 2 seconds. User can adjust the image
view by using zoom in/out button via web access, and refocus using the Auto-Focus
link on the main Web page.
Installation
1. Remove the camera from the box. Separate the bottom box from the top box using
a torx wrench (FIG.1), and remove the safety cable on the bottom box (FIG.2).
FIG.1
2. Secure the bottom box to anywhere you want by tightening the included truss-head
screws (M4.0x25) to the mounting holes marked "a" on the bottom box (FIG.3&4).
a a
a a
FIG.3
3. Firstly, insert the network cable and power cable through a pipe with ½" PT
(FIG.5), and then secure the pipe to the side hole or bottom hole (FIG.6. please
make sure the connection between the pipe and the side hole is watertight, and
the side hole is facing downwards).
Installation Guide
372
1
10 11
2
182
333
17 16
connected to a network
is in process.
FIG.2
FIG.4
66-8022CSE-1B
6 5
FIG.5
4. Attach the safety cable to the mounting hole on the bottom box (FIG.7), and
connect the network cable and power cable to the camera's RJ-45 connector
12 and power input, respectively (FIG.8).
7
13
14
FIG.7
15
5. Use a torx wrench to lock the top box to the bottom box by tightening the screws
Unit: mm
(FIG.9&10).
FIG.9
6. Adjust the three adjustment screws to turn the camera to the desired position.
Then tighten the screws (FIG.11-16).
FIG.11
FIG.13
FIG.15
Change the Outlet Position for the Network Cable and Power Cable
1. Loosen the hole plug on the bottom box and secure it to the side hole (FIG.17).
2.Insert the network cable and power cable through bottom hole on the bottom box
(FIG.18), and then connect the network cable and power cable to the camera's
RJ-45 connector and power input, respectively (FIG.8). For watertight installation,
please refer to Installation-3.
FIG.6
+12V IN
GND
–
DC12V
N.O.
GND
—
N.O.
COM.
COM.
DIN
GND
AIN
DIN
GND
AOUT
GND
AIN
GND
AOUT
—485
＋485
–485
+485
FIG.8
FIG.10
FIG.12
FIG.14
FIG.16