NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
SpacePole Display Mount, Back–to–Back Introduction This kit provides the components to install the SpacePole Display Mount, Back–to–Back. Kit Contents...
1668-K105 (Display Mount, SpacePole, Back-to-Back) Installation Procedure 1. For countertop installation, drill four holes for the mounting bolts in the desired location. Use the SpacePole Mount base as a template for locating the holes. Install the SpacePole Display Mount, Back–to–Back and secure with screws (4) or bolts (4) included in the hardware pack or with your preferred fasteners.
Page 5
1668-K105 (Display Mount, SpacePole, Back-to-Back) 3. Attach the P–Series POS main display to the SpacePole arm by sliding the bracket tabs into the head slots. 4. Tighten the thumbscrews (2) at the bottom of the bracket to secure the main display.
Page 6
1668-K105 (Display Mount, SpacePole, Back-to-Back) 5. Attach the customer display to the SpacePole arm by sliding the bracket tabs into the head slots. 6. Tighten the thumbscrews (2) at the bottom of the bracket to secure the customer display.
Page 7
1668-K105 (Display Mount, SpacePole, Back-to-Back) 7. Pivot the main display towards the back. 8. Loosen the screw on the Terminal Cable Cover. To open, press the indentations in the Cable Cover to unlatch the cover then pivot to open.
Page 8
1668-K105 (Display Mount, SpacePole, Back-to-Back) 9. Route the customer display cables to the main display and connect to the corresponding connectors. Close the Cable Cover.
Page 9
1668-K105 (Display Mount, SpacePole, Back-to-Back) 10. Route the cables from the display down the SpacePole Mount and out of the integration tray or countertop.
Page 10
1668-K105 (Display Mount, SpacePole, Back-to-Back) 11. Install the Cable Clip to secure the cables. 12. Add the integration tray cover.