Table of Contents
Advertisement
DO NOT ALLOW PAINT, WATER OR DUST TO
CONTAMINATE YOUR ALARM.
YOUR ALARM IS A MAINS 230V AC ELECTRICAL
APPLIANCE. DO NOT REMOVE THE COVER OR
INSERT ANYTHING INTO THE ALARM.
DO NOT PAINT YOUR SMOKE ALARM - IT MAY
ALARM OR CEASE TO OPERATE.
IF YOUR ALARM SOUNDS FOR NO REASON AND
WILL NOT RESET, IT CAN BE REMOVED BY
RELEASING THE CLIP ON THE BASE. SWITCH OFF
MAINS FIRST.
IF BEEPING OCCURS, CHECK THAT THE GREEN
MAINS LIGHT IS ON. PRESS THE TEST BUTTON
FOR 10 SECONDS.
THE RECHARGEABLE CELLS MAY REQUIRE A FEW
DAYS TO CHARGE AFTER FIRST BEING CONNECTED
TO THE MAINS.IT MAY GIVE A SHORT BEEP EVERY 40
SECONDS FOR UP TO 2 HOURS WHILE IT IS
CHARGING.
CHECKING & MAINTAINING YOUR ALARMS
INSPECTION & TESTING PROCEDURE
After installation, then at least weekly, check all your Alarms.
Also check after re-occupation following a holiday etc.
(i) Check that the green mains indicator light is on. (If it is off
check circuit breakers, fuses and wiring etc.) Check the red
light behind the button or on the cover flashes every 40
seconds.
(ii) Press the test button (see figure 2) for up to 10 seconds to
ensure the sensor chamber, electronics and sounder are
working. A red light behind the test button or on the cover, will
flash while horn is sounding. The alarm will stop when the
READ THIS FIRST
(SEE FIGURE 1, BELOW)
2
CONT.
.
Advertisement
Table of Contents
