Mouse Control - ADDER GEMAV2GEM Installation And Use Manual

Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):
To select channel 2:
ba2 ba2
press
To 'tab through' channels:
ba ba v
press
release

3.5 Mouse control

Computers may conveniently be selected using a three button mouse. In order to
switch to the next computer simply hold down the central mouse button (the wheel
mouse button on an IntelliMouse) and click on the left hand mouse button to select
the next computer or the right hand mouse button to select the previous computer. If
the AdderView has been set to scan active ports then the next or previous active
channel will be selected. If it has been set to scan all ports then the next or previous
numerical channel in sequence will be selected (see section 4.5 for more details).
Mouse switching may be enabled or disabled by setting options during configuration
(see section 4.3). When mouse switching is disabled the third button or wheel button
state is 'passed through' the AdderView and seen by the application software.
Hold down centre button (
Press and release left hand button
( ) to select next computer
AdderView GEM
release
v
release
v v v v
press
)
Installation and Use
2ba 2ba
v v v v
press
vba vba
release
Hold down centre button (
Press and release right hand button
( ) to select previous computer
)
Page 23