Noise And Vibration - Flex RE 14-5 115 Original Operating Instructions

RE 14-5 115
The operator can control kickback and
reaction forces by taking appropriate
precautions.
 Keep your hands away from the rotating
insertion tool.
The insertion tool may kickback over your
hand.
 Keep your body out of the area into which
the electric power tool moves when
a recoil occurs.
Kickback propels the electric power tool in the
direction opposite to the movement of the
sanding disc at the point of pinching.
 Work especially carefully near corners,
sharp edges, etc. Prevent the insertion
tool from recoiling off the workpiece and
jamming.
The rotating insertion tool has a tendency to
snag on corners, sharp edges or if it bounces.
This causes a loss of control or kickback.
 Do not use a chain or toothed saw blade.
Such insertion tools frequently cause a
kickback or the loss of control of the electric
power tool.
Special safety instructions
for sanding:
 Do not use oversized sanding sheets, but
follow the manufacturer's specifications
for the size of sanding sheets.
Sanding sheets which project over the
sanding pad may cause injuries as well as
block and rip the sanding sheets or cause
a kickback.
Special safety instructions for milling:
 Do not machine any surfaces with exposed
steel reinforcements. Risk of recoil!
 Exercise particular caution when machining
corners, edges and extreme transitions.
Milling head or milling wheels may be
damaged.
 Do not switch on the electric power tool
unless the milling wheels can rotate freely.
 Use original FLEX milling heads and milling
wheels only. Do not use any adapters or
reducers.
Additional safety instructions
 Use only extension cables permitted for
outdoor use.
 It is not recommended to sand lead paint.
Lead paint should be removed by
a specialist only.
 Do not work on materials which release
hazardous substances (e.g. asbestos).
Take precautions if hazardous, combustible
or explosive dust is likely to occur.
Wear protective dust mask.
Use dust extraction system.
a^j^db=ql=molmboqv>
 The mains voltage and the voltage
specifications on the rating plate must
correspond.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool is
typically:
– Sound pressure level:
– Sound power level:
– Uncertainty:
Total vibration values:
Total vibration values
Milling plaster surfaces
Sanding concrete surfaces
Sanding with sanding sheet
Perforating wallpaper
t^okfkd>
qÜÉ=áåÇáÅ~íÉÇ=ãÉ~ëìêÉãÉåíë=êÉÑÉê=íç=åÉï=
éçïÉê=íççäëK=a~áäó=ìëÉ=Å~ìëÉë=íÜÉ=åçáëÉ=~åÇ=
îáÄê~íáçå=î~äìÉë=íç=ÅÜ~åÖÉK
87.3 dB(A);
98.3 dB(A);
K = 3 dB.
<2.5 1.5
6.6 1.5
2.9 1.5
<2.5 1.5
19