Sun Microsystems Storage J4200 Replacement Manual page 8

3. Loosen the two captive screws using your thumb and forefinger.
Note – If the captive screws are too tight to loosen by hand, use a #2 Phillips
screwdriver to loosen each screw.
4. Push each ejector tab outward to release the SIM from the chassis. (See
FIGURE 2
FIGURE 2
5. Grasp the middle of the SIM board and slide it out of the slot.
Caution – Use care when handling either the new or failed SIM board. Make sure
all ESD precautions are being followed.
Caution – For products with multiple power cords, all power cords must be
disconnected to completely remove power from the system.
4 Sun Storage J4200 Array SIM Board Replacement Guide • April 2008
.)
Removing a Failed SIM Board