Table of Contents
Advertisement
9. WIRING
Step 1. Loosen 2 mounting screws first, then gradually
loosen 2 bracket screws alternately to slide the
choke brackets outward.
Step 2. Loosen 2 connector cover mounting screws, then
open the connector cover by sliding it.
Step 3. Run the speaker cable through the gap in the
choke bracket, then connect its RJ-45 connector
to the IR-802T connection terminal.
To avoid electric shocks, be sure to switch
off the IR-802T Infrared Wireless Tuner's
power when connecting the IR-820SP.
Notes
• Use a Category 5 plenum cable (straight type)
when routing the cable in locations where
plenum-rated cable is required.
• Cross type cables cannot be used.
• The cable length must not exceed 50 m (54.68
yd).
• Be sure to connect the connection cable from
the IR-820SP to the "TO IR-820SP" terminal on
the IR-802T's rear panel.
Never short-circuit the connector nor connect
it to the LAN terminal of other device, as this
could cause the unit failure.
Step 4. Close the connector cover by sliding it, then
retighten the 2 loosened screws to secure it.
Step 5. Gradually tighten 2 bracket screws alternately to
slide the choke brackets inward until the cable is
clamped. Then, retighten the 2 loosened mounting
screws.
14
CAUTION
Choke bracket
Connector cover
To the IR-802T's "TO IR-820SP" terminal
Bracket screw
Mounting screw
2
3
IR-802T connection
terminal
4
1
5
Advertisement
Table of Contents
