Table of Contents
Advertisement
Note
When the LAP function is active, the FLASH
button takes on the dual function of high beam
"FLASH" and LAP timer finish line storage control
(new lap start indication).
Note
The TRIP FUEL function always has top priority
over the LAP function: in case of activation of the
TRIP FUEL function with active LAP function, the LAP
timer view is automatically removed and TRIP FUEL
information is displayed instead.
LAP recording
If the LAP function is active, it is possible to record the
lap time, for a total of 30 consecutive laps.
Operation:
-
any further time the motorcycle goes through the
finish line, the just ended lap number and time
are displayed for 5 seconds with a resolution of
one hundredth of a second;
-
after these 5 seconds, the instrument panel goes
back to lap timer page referred to the new current
lap.
74
-
on the 30th lap, when the FLASH button (3) is
pressed, and every time it is pressed, current lap
is stored and the message FULL is displayed to
indicate that available storage space is full.
If the time is never stopped, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from zero and will keep
running until the lap is stopped or the recording
function is disabled.
During every lap, the following data are stored:
-
no. 30 lap times (time between consecutive start
and stop);
-
no. 30 values for max. RPM (maximum RPM
value reached in every lap);
-
no. 30 values for max. speed (maximum speed
value reached in every lap).
Advertisement
Table of Contents
