Setting Up The Lan Interface - Keysight Technologies X-Series Programming Manual

Using IO Interfaces
Using LAN

Setting Up the LAN Interface

For LAN operation, the signal generator must be connected to the LAN, and an
IP address must be assigned to the signal generator either manually or by
using DHCP client service. Your system administrator can tell you which
method to use. (Most modern LAN networks use DHCP.)
Verify that the signal generator is connected to the LAN using a 100Base–
T LAN or 10Base–T LAN cable.
Configuring the VXI–11 Service
To communicate with the signal generator over the LAN, you must enable the
VXI–11 SCPI service. Select VXI–11 until On is highlighted. (Default condition
is On.)
Utility > IO Config
NOTE
For optimum performance, use a 100Base–T LAN cable to connect the signal generator to the LAN.
For details on each key or for a list of equivalent SCPI commands, use the front-panel key help. For information describing the
key help, refer to "Getting Key Help" on page 30
SCPI Command Reference.
Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide
and the User's Guide. For additional SCPI command information, refer to the
43