Using The Web Browser - Keysight Technologies X-Series Programming Manual

Getting Started with Remote Operation

Using the Web Browser

Using the Web Browser
The following example for accessing the Web-Enabled X-Series web page
uses the newly shipped instrument's predetermined default hostname
(a-<instrument model number>-<last 5 digits of the instrument serial
number>).
The procedure that follows assumes the signal generator is running
firmware A.01.20 or later.
Web-Enabled SCPI command capability is not available for versions of
Internet Explorer
versions.) To use the Telnet SCPI, refer to the figure on
For more information on LAN Connectivity, refer to the Keysight
Connectivity Guide (E2094-90009) or to the LAN Connectivity FAQs for
details on using the instrument over LAN.
The instrument can be accessed through a standard web browser, when it is
connected to the LAN. To access through the web browser, enter the
instrument IP address or the hostname as the URL in your browser. Refer to
Figure 1-2, "The Signal Generator Web Service" on page
The signal generator web page, shown at right and
information on the signal generator, FTP access to files stored on the signal
generator, and a means to control the instrument using either a remote
front-panel interface or SCPI commands. The web page also has links to
Keysight's products, support, manuals, and website. For additional information
on memory catalog access (file storing), and FTP, refer to the User's Guide and
"" on page 220
on page
The Web Server service is compatible with the Microsoft Internet Explorer (6.0
and newer) web browser and operating systems Windows 2000, Windows XP,
and newer. For more information on using the Web Server, refer to
the Signal Generator Web Server" on page
Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide
≥
7.0. (The SCPI Telnet softkey is inactive for these
and for FTP, see
231.
page
"Using FTP" on page 56
26.
page 24.
24.
27, provides general
and "FTP Procedures"
"Enabling
23