Advertisement
Seamless switch effects
Step 7
Setting SCALE
Click the Scale button to enter the Scale settings menu.
Click the UP or DOWN button to select the desired content
of Horizontal size horizontal SCALE size, Vertical size
vertical size, Horizontal position horizontal X coordinate,
Vertical position vertical Y coordinates, click the SEL key
to enter the setup menu, corresponding to a "*" instead of
">", use the UP or DOWN to change the setting value, click
the SEL to complete the setup and exit the current menu
Press UP or DOWN key when, SCALE value
NOTE
will change more quickly. Rate of change from
1 to 10 to100 pixels
Step 8 -Save
VSP 310 supports two users modes. Press SAVE
button, SAVE1 and SAVE2 button will light up at the
same time, press SAVE1 or SAVE2 will finish save
operation.
SAVE1 is the default user mode of VSP 310,
NOTE
VSP 310 will work with SAVE1 configuration
data after power on. After factory reset, all user-mode
will go to initial mode.
Remote control
Address:S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197
Email: rgblinkcs@gmail.com
software operation
Fax:00865925771202
http://www.rgblink.com
This software is only setup for windows
NOTE
system, please refer to the user manual for
detail. During install and application, please use right
language interface.
Step 1-Set up communication
Use the RS 232 port on the computer, baudrate should
be 115200.
Set com
Step 2-Set up output resolution
Select output resolution from pull down
output list.
Step 3-Local control
Step 4 -set spliter function
Use mouse to push
mosaic function page on
the software, select
horizontal mosaic or
vertical mosaic, and set
X,Y position in need.
Step 5-Set Scale
User can scale the image with mouse drap and drop
operation; User can also scale by input the data into the
scale parameters and set.
Step 6-Save
Push "Save to flash" button and
select one of user mode to save, there
are three user mode in the list.
Open com
Close com
Seamless switch
Use mouse to push
seamless switch page on
the software, select
seamless function by
click and click on the
source to switch with
the effect.
Save to flash
button, use
to save user
mode
VSP 310 Quick Start
Rev 1.0
Page3 of 3
Advertisement
