Dell PowerEdge FC830 Owner's Manual page 90

4. Remove the IDSDM card.
CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the
system.
Steps
1. Align the following:
● The slot on the card edge with the projection tabs on the tarjeta intermedia PCIe support.
● The two screw holes on the IDSDM card with the standoffs on the system board.
● The hole on the SD card slot bracket with the screw hole on the IDSDM card.
2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
Figure 31. Installing the IDSDM card
1. IDSDM card
3. SD card slot bracket
5. connector
Next steps
1. If applicable, install the SD card(s) and the internal USB key.
2. Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Sustitución de la llave de memoria USB interna opcional
Replacing an SD card on page 86
Después de trabajar en el interior de su equipo
90 Instalación y extracción de componentes del sled
on page 50
on page 51
on page 51
2. screw (2)
4. tarjeta intermedia PCIe support bracket
6. standoff (2)
on page 87