Dell PowerEdge FC830 Owner's Manual page 101

Installing a hard drive or SSD
Prerequisites
CAUTION: When a replacement hot-swappable hard drive or SSD is installed and the sled is turned on, the hard
drive or SSD automatically begins to rebuild. Make absolutely sure that the replacement hard drive or SSD is
blank or contains data that you wish to have over-written. Any data on the replacement hard drive or SSD is
immediately lost after the hard drive or SSD is installed.
NOTE: You must remove a hard drive or SSD to upgrade a hard drive or SSD or replace a faulty hard drive or SSD.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the hard drive or SSD or hard drive or SSD blank.
NOTE: All operating systems do not support hot-swappable drive installation. See the documentation supplied with your
operating system.
Steps
1. Press the release button to open the hard drive or SSD carrier handle.
2. Slide the hard drive or SSD carrier into the drive bay. Carefully align the channel on the hard drive or SSD carrier with the
appropriate drive slot on the sled.
3. Push the drive carrier into the slot until the handle makes contact with the sled.
4. Rotate the carrier handle to the closed position while pushing the carrier into the slot until it locks into place.
The status LED indicator displays a steady green light if the drive is installed correctly. The drive carrier LED green indicator
flashes as the drive rebuilds.
Figure 43. Installing a hard drive
1. release button
3. hard drive
2. hard drive(on backplane)
4. hard drive carrier handle
Instalación y extracción de componentes del sled 101