Dell PowerEdge FC830 Owner's Manual page 51

Before working inside your system
Steps
1. Turn off the sled using the CMC.
2. Remove the sled from the enclosure.
3. Install the I/O connector cover.
Después de trabajar en el interior de su equipo
Requisitos previos
Siga las pautas de seguridad que se enumeran en la sección Instrucciones de seguridad.
Pasos
1. Coloque el sled en el gabinete.
2. Encienda el sled.
Herramientas recomendadas
Necesita las siguientes herramientas para llevar a cabo los procedimientos de extracción e instalación:
● Llave para la cerradura del bisel.
La llave es necesaria únicamente si el sistema incluye un bisel.
● Destornillador Phillips núm. 1
● Destornillador Phillips núm. 2
● Destornilladores Torx n.º T8 y n.º T10
● Llave para tuercas hexagonales de 5 mm y 6 mm
● Muñequera de conexión a tierra
SLED
Removing the sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Turn off the sled using the operating system commands or the CMC, and ensure that the front panel indicator of the sled is
not lit.
Steps
1. Press the release button on the sled handle to unlock the sled handle.
2. Rotate the sled handle away from the sled to disengage the sled from the midplane connectors.
3. Slide the sled out of the enclosure.
Instalación y extracción de componentes del sled 51