Dell PowerEdge FC830 Owner's Manual page 117

2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the hard-drive or SSD backplane.
NOTE: You must remove the hard-drive or SSD backplane to replace a faulty hard-drive or SSD backplane or service
other components inside the system.
Steps
1. Align the retention screws on the hard-drive or SSD backplane cable connector with the screw holes on the system board
connector.
2. Tighten the two retention screws to secure the backplane cable connector on the system board.
3. Install the hard-drive or SSD cage.
4. Align the retention screws on the hard-drive or SSD backplane with the screw holes on the hard-drive or SSD cage.
5. Lower the hard-drive or SSD backplane into place until the retention screws on the hard-drive or SSD backplane engage
with the screw holes on the hard-drive or SSD cage.
6. Tighten the retention screws to secure the hard-drive or SSD backplane on the system board.
7. Connect the power cable to the backplane.
Figure 58. Installing a 2.5-inch (x8) SAS hard-drive or SSD backplane
1. alignment pin (2)
3. retention screw on the top of the hard-drive or SSD
backplane (4)
5. hard-drive or SSD backplane cable connector
7. retention screw on the bottom of the hard-drive or SSD
backplane (4)
Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
2. power cable
4. hard-drive or SSD backplane
6. hard-drive or SSD backplane cable
8. screw holes on the hard-drive or SSD cage (6)
Instalación y extracción de componentes del sled 117