Ravas RPW-310-EL Operator's Manual page 11

Press the key to go up a value or press the
∧

required value is reached.
Press < to change to the next digit.

Repeat this procedure until the required piece weight is displayed.

To accept the new value press ENTER (↵).

The display shows the number of pieces currently on the weighing system.

You may make a printout and add up the weights. A special printout will be made
which includes the piece weight sampled and the number of pieces. (See option
printer).
To return to the normal weigh mode press the
to normal weighing mode the piece count total will be lost.
SUMMING
The indicator offers the possibility to add weighings and show the total weight. When
a tare weight is active, the net weight is added automatically.
Load the system with the weight that should be added.

Press the key to add the weighed load to the total weight.

The display shortly shows the message "ADDED" and then automatically

returns to the weighing mode.
If a printer is installed, a printout will be made. The gross, net and tare weights

are totalled.
No weight can be recorded twice. The system needs to be returned to the net

zero-range before another weight can be added up.
The subtotal can be checked by pressing the

The display shows the net total weight and the number of weightings totalled

so far repeatedly for 3 seconds.
If the key is pressed shortly during this period, the total is printed out (if

option is installed) and reset to 0.
If the "CE" key is pressed during this period, the total is reset but not

printed out.
If no key is pressed during this period, the subtotal stays in memory and

the system returns to the weighing mode after 60 seconds.
CHANGE UNITS
The system is set to start up in 'kgs' or in 'lbs'. However you may, at any time in the
weighing mode, change to the second unit (lb⇔kg or kg⇔lb).
 Press the
key for 3 seconds.
❏ The display will show the current weight in the new units for 5 seconds and
then automatically change back to the start up units.
The same key is used to change from the piece counting mode back to the weighing
mode.
key to go down a value until the
∨
key for 3 seconds. Once you return
key for 3 seconds.
11