Email Notification Settings - IBM 10G Network Active Bypass User Manual

Email notification settings

Use the Email Notification page to configure email servers and accounts, and to set up the 10G Network
Active Bypass unit to send email messages when the switching mode of a segment has changed.
The following settings are used for configuring email servers and accounts, and for setting up email
notifications:
Table 11. Email notification settings
Field
Email Notification
Outgoing Mail Server (SMTP)
Outgoing Mail Server (SMTP) Port
SMTP User Name
SMTP Password
Outgoing Server (SMTP) Security
From (Sender's Email Address)
To (List of recipients, comma
separated)
Subject
Heartbeat status template
Power template
Description
Enable or disable email notification
Address of the appropriate outgoing
SMTP mail server
Port number of the outgoing SMTP
mail server
User name for the outgoing SMTP
mail server
Password for the outgoing SMTP
mail server (if applicable)
SSL encryption used between the
SMTP mail server and mail client
The name or email address of the
sender, which is displayed in the
From field of an outgoing email
message.
The names or email addresses of the
people the message is sent to, which
are displayed in the To field of an
outgoing email message.
The subject of the email, which is
displayed in the Subject field of an
outgoing email message.
Template for email notification of
heartbeat status change
Template for email notification of
power supply status change
Chapter 2. Setting up the 10G Network Active Bypass unit
Default
Disabled (Don't send)
25
Enabled (Secured)
Heartbeat segment ${segment}:
state=${hb_state_name},
OpMode=${op_mode_name}
Power: supply ${power_supply} is
${power_state?OFF:ON}
19