Crystal Mountain Mogul Removal And Installation

Removal and Installation
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water Cooler Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
. Crystal Guard
Removal & Installation Procedure
REMOVAL
1. Remove the locking pin located at rear of Crystal Guard (figure 1-1).
2. Place finger tips of both hands on the Crystal Guard (figure 2-1) and turn it counter clockwise until it is free from the
cooler (figure 2-2) opening and remove from the cooler (figure 2-3).
3. To reinstall reverse these steps.
Note: Remember to replace locking pin to secure Crystal Guard to cabinet.
INSTALLATION
If you take apart the Crystal Guard for sanitation or because a part of it needs replacing, reassemble as below.
4. Ensure that the Crystal Pin has the O-Ring in place at its base firmly insert the Crystal Pin inside the Crystal Guard (figure 4-1). Make
sure that the Crystal Pin's four locking tabs have completely protruded through the locking tabs entries (figure 4-2).
Note: Ensure that the Crystal Pin has the O-Ring in place.
5. Using the Crystal Guard removal tool (SMT-C000110) to insert clean pin in guard (figure 5-1). Twist the Crystal Pin
clockwise until the four locking tabs are approximately half way between the four holes (figure 5-2).
figure 1-1
figure 2-1 figure 2-2
figure 4-1
figure 5-1
figure 2-3
figure 4-2
figure 5-2
5- 1