Advertisement
5. Mount the CAN AccuBoom node in a suitable located in the cable
compartment.
6. Connect the AccuBoom cable to the AccuBoom node.
a. Connect the rectangular connectors from the AccuBoom Cable P/N
115-1001-011 to the CAN Accuboom Node P/N 063-0172-316.
Node Connection
7. Connect supplied CAN Tee cable (115-0171-326) to the CAN
connection on the CAN AccuBoom cable P/N 115-1001-011.
8. If using a Viper or Viper Pro console connected serially to the
SCS 460, connect the orange wire from the AccuBoom harness
(115-1001-011) to the Master Apply Switch so that the orange
wire is supplied power when the Master Apply switch is in the
"ON" position. If you are not using a Viper or Viper Pro connected
serially to the SCS 460, orange wire is not needed for installation.
Manual #016-0171-081 Rev. B 07-08
5
Advertisement
