Metal Parts; Saw Blade - Omegasonics RESTORATION PRO Operation & Instruction Manual

Metal Parts

· In the ultrasonic bath, preheat 1 part OmegaSupreme with 10 parts clean water to a
temperature of 150˚F.
· Place the metal parts into the basket with the cavity containing heaviest residue
facing the bottom of the basket.
· Submerge the basket into the bath and rotate the housings (if applicable) keeping
them underneath the surface to allow air bubbles to be removed from the part.
· Clean the part for 5 minutes.
· Once completed, rotate the part 180˚ if the part facing opposite the ultrasonic
transducers is heavily soiled.
· If necessary, clean the part for an additional 5 minutes.
· Once the part is cleaned, remove from the bath and rinse using water that is 150˚F.
· Blow off the excess water using compressed air.
· Due to the heat of the metal, after being removed from the bath, it will dry quickly, on
its own ("flash dry").
Saw Blades
· In the ultrasonic bath, preheat 1 part OmegaChem with 10 parts clean water to a
temperature of 160˚F.
· Arrange the saw blades into the basket vertically and space them so they don't
"nest" together.
· Submerge the basket and clean for 5 – 10 minutes, depending on contamination and
number of blades in basket.
· Once clean, remove from the bath and rinse with hot water that is 160˚F.
· Blow off excess moisture with compressed air.
· Due to the heat of the metal, after being removed from the bath, it will dry quickly, on
its own ("flash dry").
· Blades must then be immediately placed into a rust protectant solution: WD40,
machining oil or a silicon protectant such as OmegaRust Protectant to prevent
immediate rusting.
17